Tube light wiring

1)In order to lighten a dim area, we to ignite a light,So It requires

• 40Watts 230v Argon gas fluorescent Tube light
• Tube light Frame
• 0.4Amps,40watts,230v  Choke
• 40Watts,230V Starter
• 230vAc Main Supply with Frequency 50 to 60 Hertz.

2)Wiring circuit diagram is shown above,If it is ok to use,use it.other wise follow the below steps.

• Connect the 230v phase wire to one end of choke
• connect another end to the tube light holder left below side.
• connect tube light holder left above side to one end of starter holder.
• Another end of starter holder is connected to right end up side of tube light holder.
• tube light holder right below side is connected to the neutral point.

3)Now connection is over,connect the bulb and checking all safety measures, give the supply.And this is only applicable for 230V 50Hz main supply.

4)Good luck