BATTERY LEVEL INDICATOR

WORKING

The LM3914 uses ten comparators, which are internally assembled in the voltage divider network based on the current-division rule. So it divides the battery level into ten parts.The circuit derives the power supply for its operation from the battery of the device itself. It uses ten LEDs wired in a 10-dot mode. The use of different coloured LEDs makes it easier to recognise the voltage level on the basis of the calibration made. Red LEDs (LED1 through LED3) indicate battery capacity of less than 40 per cent. Orange LEDs (LED4 through LED6) indicate battery capacity of 40 to less than 70 per cent and green LEDs (LED7 through LED10) indicate battery capacity of 70 to under 100 per cent. The brightness of the LEDs can be adjusted by varying the value of preset VR2 between pins 6 and 7. Diode D1 prevents the circuit from reverse-polarity battery connection. The tenth LED glows only when the battery capacity is full, i.e., the battery is fully charged. When the battery is fully charged, relay-driver transistor T1 conducts to energise relay RL1. This stops the charging through normally-open (N/O) contacts of relay RL1. For calibration, connect 15V variable, regulated power supply and initially set it at 3V. Slowly adjust VR1 until LED1 glows. Now, increase the input voltage to 15V in steps of 1.2V until the corresponding LED (LED2 through LED10) lights up.Now the circuit is ready to show any voltage value with respect to the maximum voltage. As the number of LEDs is ten, we can easily consider one LED for 10 per cent of the maximum voltage.

PARTS

IC=LM3914

LED

Resistor=As per in circuit